Here's a G&L neck I ordered and fitted to an NRD Basses body. Took a bit of reshaping at the end of the neck pocket to get the same shape as the G&L neck and I had to add some thin mahogany veneer either side of the pocket to take up the slack. Nice and snug now.
Also, because the G&L neck has a few extra frets, I had to use a Badass II bridge I had (because of the extra metal
behind the screw holes compared to a std Fender bridge) and moved it towards the neck the required amount. And because of that extra metal, it covered the 5 original holes where the bridge would usually go. Everybody understand that??
I also had to enlarge the peg holes for the tuners, as I found out that the Legacy series have a small dia hole. Currently strung up with Roto stainless 45-105. Used it last night at rehearsal and it sounded brilliant - better than I hoped actually. Currently in bits now and waiting for a finish of some sort. Contemplating a green or purple burst using stain and Tru Oil, with matching headstock.....
Here's a spec list:
Body is NRD (ebay and very nice for the money)
Pickup is SD Quarter Pounder
Pickguard is ebay cheapie
Fender Neck plate
CTS 250k Pots
PETP 0.033uF Cap
Hipshot string tree
Cheap ebay tuners
Attachment:
G&L Bitsa.jpg [ 68.73 KiB | Viewed 3596 times ]
