I had a little time this morning to mess around, so I thought I'd throw this together for you guys.
The Challenge: Match the sound sample with the bass that was used!
The Prize: Look cool on the internet!
The Basses:
Fender Custom Shop '64 NOS - V/V/T all set on full, stock electronics and pups, fairly new DR Sunbeam strings, alder body, rosewood board.
Warmoth Fretless (if you don't get this one, you should take up drums.
) - V/V/T all set on full, Duncan Antiquity II p'ups, passive electronics, half-dead Fender Bullet strings, ash body, ebony board with no lines.
Ernie Ball/Music Man Stingray 4 - Volume on full, EQ all flat (center detent), stock pickup, stock 3-band electronics, fairly-new Elixr strings (I got these as samples when I used to test for them), rosewood board, ash body.
Zon Sonus 519 - Volume on full, EQ all flat (center detent), Bart pups, Bart ZB4 preamp, fairly new DR Sunbeam strings, ash body, buckeye top, graphite neck, phenowood board.
Mike Lull M5V - Volume on full, EQ all flat (center detent), Aguilar OBP-3 pre, Duncan single coils (custom wound for Mike Lull), mostly-dead DR Sunbeam strings, ash body, maple board.
Roscoe SKB3006 - Volume on full, EQ all flat (center detent), Bart pre, Bart/Roscoe pups, really-dead Infeld IN366 srings, spanish cedar body, pau ferro board.
Here are the samples... it's my dumb rendition of a Sugar Hill Gang classic:
SAMPLE 1SAMPLE 2SAMPLE 3SAMPLE 4SAMPLE 5SAMPLE 6Good luck!!!